Configuring a 2370, 2360, or 2380 Switch for Basic Service 83WLAN—Security Switch 2300 Series Installation and Basic Configuration Guide3 When you are prompted for your old password, press Enter.Enter old password:4 When you are prompted for a new password, enter an enable password of up to 32 alphanumericcharacters, with no spaces.Enter new password:The password you enter is not displayed.5 When you are prompted to retype your password, reenter the enable password.Retype new password:WSS Software does not display your password, but lets you know that the enable password is set:success: password changedConfiguring the Time and DateTo set the system time and date:1 Set the time zone to specify the offset from Coordinated Universal Time (UTC).2 Configure WSS Software to offset the time by an additional hour for daylight savings time or similarsummertime period, if applicable.3 Specify the IP address of a Network Time Protocol (NTP) server or statically set the time and date.To configure time and date parameters, use the following commands:set timezone zone-name {-hours [minutes]}set summertime summer-name [start week weekday month hour min end week weekday monthhour min]set timedate {date mmm dd yyyy [time hh:mm:ss]}set ntp {enable | disable}set ntp server ip-addrNote. Nortel recommends that you set the time and date parameters before you installcertificates on the WSS. Generally, certificates are valid for one year beginning with thesystem time and date that are in effect when you generate the certificate request. If theswitch’s time and date are incorrect, the certificate might not be valid.