82 Configuring a 2370, 2360, or 2380 Switch for Basic Service320656-AFigure 21. Example Nortel NetworkConfiguring an Enable PasswordWSS Software does not require you to change the enable password from the default (null string). However,Nortel recommends that you configure an enable password to provide at least minimal security to the WSSbefore you proceed to more advanced configuration options.To configure an enable password, use the following command:set enablepassTo configure an enable password:1 If you are not already at the enabled access level, enter the enable command.2370> enable2 At the enabled prompt, enter set enablepass.2370# set enablepassAP-2330RouterRouterWiredauthenticationclientSystem IP address10.10.10.4AP-2330Port1Port2Port4WSS110.10.40.19/2410.10.20.19/2410.10.30.19/24RADIUSservers10.10.70.2010.10.70.4010.10.60.18/2410.10.60.19/24WMSPort3AP-2330Layer 2AP-2330 System IP address10.10.40.4WSS2Layer 2AP-233010.10.10.19/24System IP address10.10.50.4WSS3Port5VLANs on WSS1VLAN 2 mgmt, port 5, 10.10.10.4/24VLAN 4 blue, port 5, tag 20, 10.10.20.2/24VLAN 3 red, port 5, tag 30Layer 2serial-id 0322199998serial-id 0322199999serial-id 0322199997serial-id 0322199996serial-id 0322199995 10.10.50.19/24