94 Configuring a 2370, 2360, or 2380 Switch for Basic Service320656-ADisplaying Certificate InformationUse the following command to display administrative certificate information:show crypto certificate adminThis command displays the following information about the certificate:• X.509 version number• Serial number• Subject (the certificate holder’s identifying information)• Signature algorithm used by the signer of the certificate• Issuer information (CA information, unless the certificate is self-signed)• Period during which the certificate is validInstalling a Server Certificate for Network UsersTo use an 802.1X authentication protocol that includes local EAP processing on a WSS, the switch must havea server certificate. You can generate a certificate on the switch itself or install a certificate assigned by acertificate authority (CA). If you use a certificate assigned by a CA, you also need to install the CA’s owncertificate for validation.The command syntax for installing certificates for management by WLAN Management Software or WebView and installing certificates for network users is very similar. The CLI commands for configuring networkuser authentication use the eap option instead of the admin option, but are otherwise the same. Likewise, theprocedures are the same.Note. If you use an authentication protocol that uses EAP-TLS on the WSS, users alsoneed certificates. (For more information, see the Nortel Mobility System SoftwareConfiguration Guide.)
