WSS Setup Methods 75WLAN—Security Switch 2300 Series Installation and Basic Configuration GuideEmail Address:Unstructured Name:Self-signed cert for admin is-----BEGIN CERTIFICATE-----MIICUzCCAbygAwIBAgICA+cwDQYJKoZIhvcNAQEEBQAwNjELMAkGA1UEBhMCVVMxCzAJBgNVBAgTAkNBMRowGAYDVQQDFBF0ZWNocHVic0B0cnB6LmNvbTAeFw0wMzA0...Lm8wmVYLxP56MpCUAm9O8C2foYgOY40=-----END CERTIFICATE-----8 Save the configuration changes:2361# save configsuccess: configuration saved.WLAN Management Software Requirements• WLAN Management Software Version 4.0 or higher must be installed and the WLAN Management SoftwareServices must be running.• The WLAN Management Software Services option to accept remote connections must be enabled. (This option isdisabled by default.)• The WLAN Management Software Services option to always accept self-signed certificates must be enabled. Thisis required if you are using the drop-ship option with an 2350, or you have staged any model switch with aself-signed certificate. (This option is disabled by default.)• The network plan containing the WSSs must be open.Preconfiguring the switch in the network plan is optional. If you know the switch’s serial number, you can preconfigurethe switch in the network plan, and let WLAN Management Software Services deploy the configuration to the switch.If you do not know the switch’s serial number, you still can use WLAN Management Software to configure the switch.However, you will need to wait for the switch to contact WLAN Management Software , so you can upload the switch’sconfiguration, modify the configuration, then deploy the modified configuration back to the switch.Preconfiguring a Switch in WLAN Management SoftwareIf you know the switch’s serial number, use the following procedure to set up the switch’s configuration in WLANManagement Software .1 Start WLAN Management Software Services.2 Start a WLAN Management Software client and connect to WLAN Management Software Services.3 Select Tools > WLAN Management Software Services Setup from the menu bar in the main WLANManagement Software window. The WLAN Management Software Services Setup wizard appears.4 On the Service Settings tab of the wizard (displayed by default), select Allow remote access, in theAccess Control area.5 Select the WSS Connection Settings tab.6 Select Accept self-signed certificates, in the Connection Security area.
