Configuring PoE switch parameters using the CLI 159poe poe-pd-detect-type{802dot3af | 802dot3af_and_legacy | Unit}The poe poe-pd-detect-type command is executed in the GlobalConfiguration command mode.ATTENTIONYou must ensure that this setting is the correct one for the IP appliance youuse with the switch. Please note this setting applies to the entire switch, notport-by-port. So, you must ensure that this setting is configured correctly for allthe IP appliances on a specified switch.describes the parameters and variables for the poe poe-pd-detect-typecommand.Table 34poe poe-pd-detect-type command parameters and variablesParameters andvariables Description802dot3af |802dot3af_and_legacySets the detection method the switch use to detect power needs of devicesconnected to front ports:• 802dot3af• 802dot3af_and_legacyATTENTIONThe default setting is 802dot3af. Ensure that the power detection methodyou choose for the Ethernet Routing Switch 2500-PWR matches that usedby the IP devices you are powering.Unit Set the unit in stack to apply the detection method.poe poe-power-usage-threshold commandThe poe poe-power-usage-threshold command lets you set apercentage usage threshold above which the system sends a trapfor each Ethernet Routing Switch 2500-PWR. The syntax for the poepoe-power-usage-threshold command is:poe poe-power-usage-threshold {<1-99> | Unit}The poe poe-power-usage-threshold command is executed in theGlobal Configuration command mode.Nortel Ethernet Routing Switch 2500 SeriesOverview — System ConfigurationNN47215-500 (323162-B) 02.02 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
