196 System configuration using the CLISetting boot parametersYou can reboot the switch and configure BootP. The topics covered in thissection are:• "boot command" (page 196)• "ip bootp server command" (page 196)• "no ip bootp server command" (page 197)• "default ip bootp server command" (page 197)boot commandThe boot command performs a soft-boot of the switch. The syntax forthe boot command is:boot [default]The boot command is executed in the Privileged EXEC command mode.Table 60 "boot command parameters and variables" (page 196) describesthe parameters and variables for the boot command.Table 60boot command parameters and variablesParameters andvariables Descriptiondefault Restores switch to factory-default settings afterrebooting.ATTENTIONWhen you reset to factory defaults, the last reset count and reason for last resetwill not be set to factory defaults.ip bootp server commandThe ip bootp server command configures BootP on the currentinstance of the switch or server. The syntax for the ip bootp servercommand is:ip bootp server {default-ip|last|disable|always}The ip bootp server command is executed in the Global Configurationcommand mode.Table 61 "ip bootp server command parameters and variables" (page197) describes the parameters and variables for the ip bootp servercommand.Nortel Ethernet Routing Switch 2500 SeriesOverview — System ConfigurationNN47215-500 (323162-B) 02.02 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
