Configuring LLDP using the CLI 217Figure 76 "show autotopology settings command output" (page 217) displaysa sample output of the show autotopology settings command.Figure 76show autotopology settings command outputshow autotopology nmm-tableThe show autotopology nmm-table command displays informationabout the network management module (NMM) table. The syntax for theshow autotopology nmm-table command is:show autotopology nmm-tableThe show autotopology nmm-table command is executed in thePrivileged EXEC command mode.The show autotopology nmm-table command has no parametersor variables.Figure 77 "show autotopology nmm-table command output" (page217) displays a sample output of the show autotopology nmm-tablecommand.Figure 77show autotopology nmm-table command outputConfiguring LLDP using the CLIYou can enable the LLDP using the CLI. For more information about LLDP,see "Link Layer Discovery Protocol (IEEE 802.1ab)" (page 74). This sectioncovers the following commands:• "lldp command" (page 218)• "default lldp command" (page 219)• "lldp config-notification command" (page 219)Nortel Ethernet Routing Switch 2500 SeriesOverview — System ConfigurationNN47215-500 (323162-B) 02.02 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
