200 System configuration using the CLIcopy tftp config commandThe copy tftp config command retrieves the system configuration filefrom the TFTP server and uses the retrieved information as the currentconfiguration on the system.The syntax for the copy tftp configcommand is:copy tftp config [address ] filename The copy tftp config command is executed in the Privileged EXECcommand mode.Table 64 "copy tftp config command parameters and variables" (page200) describes the parameters and variables for the copy tftp configcommand.Table 64copy tftp config command parameters and variablesParameters andvariables Descriptionaddress XX.XXX>Specifies the TFTP server IP address; enter indotted-decimal notation.filename Enter the name of the configuration file you want to copyfrom the TFTP server.Customizing the opening bannerYou can customize the banner that appears when you connect to theEthernet Routing Switch 2500 Series. You can customize the text that readsNORTEL. However you cannot customize the second line that reads Enter[Ctrl]+y to begin.The Banner Control feature provides an option to specify the banner text.If you choose not to display the banner, the system enters the commandmode through the default command interface. You do not have to pressthe Ctrl+y keys.The Banner display that you select is used for subsequent console sessions.For executing the new mode in the console, you must logout. For Telnetaccess, all subsequent sessions use the selected mode.This section contains information about the following commands:• "banner command for displaying banner" (page 201)• "show banner command" (page 201)• "no banner command" (page 202)Nortel Ethernet Routing Switch 2500 SeriesOverview — System ConfigurationNN47215-500 (323162-B) 02.02 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
