Configuration Management 189• "show config-network command" (page 190)configure network commandThe configure network command lets you load and execute a scriptimmediately and to configure parameters to automatically downloada configuration file when you reboot the switch. The syntax for theconfigure network command is:configure network [load-on-boot{disable|use-bootp|use-config}] [filename ] [address]The configure network command is executed in the User Exec mode.ATTENTIONWhen you enter configure network with no parameters, the system promptsyou for the script file name and TFTP server address and then downloads thescript.Table 56 "configure network command parameters and variables" (page189) describes the parameters and variables for the configure networkcommand.Table 56configure network command parameters and variablesParameters andvariables Descriptionload-on-boot {disable|use-bootp|use-config Specifies the settings for automatically loading a configuration filewhen the system boots:• disable—disables the automatic loading of config file• use-boot—specifies using the BootP file as the automaticallyloaded config file• use-config—specifies using the ASCII configuration file as theautomatically loaded config fileATTENTIONWhen you enter configure network with no parameters, thesystem prompts you for the script file name and TFTP serveraddress and then downloads the script.If you omit this parameter, the system immediately downloadsand runs the ASCII config file.Nortel Ethernet Routing Switch 2500 SeriesOverview — System ConfigurationNN47215-500 (323162-B) 02.02 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
