160 Power over Ethernet for the Ethernet Routing Switch 2526T-PWR and 2550T-PWRTable 35 "poe poe-power-usage-threshold command parameters andvariables" (page 160) describes the parameters and variables for the poepoe-power-usage-threshold command.Table 35poe poe-power-usage-threshold command parameters and variablesParameters andvariables Description<1-99> Enter the percentage of total available power youwant the switch to use prior to sending a trap.ATTENTIONThe default setting is 80%.Unit Set a percentage usage threshold above which thesystem sends a trap for each unit.poe poe-trap commandThe poe poe-trap command enables the traps for the PoE functions onthe Ethernet Routing Switch 2500-PWR. The syntax for the poe poe-trapcommand is:poe poe-trap {Unit}The poe poe-trap command is executed in the Global Configurationcommand mode.no poe-trap commandThe no poe-trap command disables the traps for the PoE functions onthe Ethernet Routing Switch 2500-PWR. The syntax for the no poe-trapcommand is:no poe-trap {Unit}The no poe-trap command is executed in the Global Configurationcommand mode.Configuring PoE port parameters using the CLIYou can configure power parameters for each port on the Ethernet RoutingSwitch 2500 PWR Series using the CLI. You enable the power and setthe power limit and power priority on each port. This section covers thefollowing topics:• "no poe-shutdown command" (page 161)Nortel Ethernet Routing Switch 2500 SeriesOverview — System ConfigurationNN47215-500 (323162-B) 02.02 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
