Customizing your system 197Table 61ip bootp server command parameters and variablesParameters andvariables Descriptionlast|needed|disable|alwaysSpecifies when to use BootP:• default-ip—use BootP or the default IP• last—use BootP or the last known address• disable—never use BootP• always—Always use BootPno ip bootp server commandThe no ip bootp server command disables the BootP server. Thesyntax for the no ip bootp server command is:no ip bootp serverThe no ip bootp server command is executed in the GlobalConfiguration command mode.The no ip bootp server command has no parameters or values.default ip bootp server commandThe default ip bootp server command sets the BootP server statusto BootP or Default IP. The syntax for the default ip bootp servercommand is:default ip bootp serverThe default ip bootp server command is executed in the GlobalConfiguration command mode.The default ip bootp server command has no parameters or values.Setting TFTP parametersYou can display the IP address of the TFTP server, assign an IP addressyou want to use for a TFTP server, copy a configuration file to the TFTPserver, or copy a configuration file from the TFTP server to the switch to useto configure the switch. This section covers:• "show tftp-server command" (page 198)• "tftp-server command" (page 198)• "default tftp-server command" (page 199)• "no tftp-server command" (page 199)Nortel Ethernet Routing Switch 2500 SeriesOverview — System ConfigurationNN47215-500 (323162-B) 02.02 Standard4.1 19 November 2007Copyright © 2007, Nortel Networks.
