Chapter 3: Link maintenance commands 115Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance Guideread linkUse this command to reconfigure a link from the parameters saved in a file.If you do not provide a file name, the file name specified in the link controlfile is used. Configuration files can be read from any specified directory.You are asked to confirm the parameters. A “yes” response to the confirmprompt reconfigures the link. A “no” response aborts the command.Command format:mlusr> read link link_number [filename]Note: The maximum length of the file name is 14 characters. The filename must follow a slash character; for example, /saveconfig1.Example:To reconfigure link number 1 from file saveconfig1:mlusr> read link 1 /saveconfig1Protocol: X25 Link type: 2Machine ID: x25destDelay: 0Port type: X Physical DTE(0)/DCE(1): 1PDN type: 44 Maximum Frame length: 135Baud rate: 19200 Fail timer: 150RFS timer: 150 Internal address: 1Remote address: 3 T1: 30Maximum out frames (K): 7 Maximum trans attempts (N2): 7Local DTE address: 000000990100Flow control negotiation: 0 Incoming packet size: 128Outgoing packet size: 128 Incoming window size: 2Outgoing window size: 2 Throughput negotiation used: 0Incoming throughput class: 10 Outgoing throughput class: 10Lowest LCN for DTE/DCE: -1 Highest LCN for DTE/DCE: -1Lowest LCN: 1 Highest LCN: 4095LOC LIC: -1 HOC HIC: -1T10: 1800T11: 2000 T12: 1800T13: 1800 T14: 600T15: 1500 T16: 1300Maximum T12 retries: 3 Maximum T13 retries: 3Confirm? (yes or no): y
