Chapter 2: Application Module commands 79Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance GuidestartNSE—activate Ethernet LAN supportThis command allows you to invoke the networking feature based on theNetwork Service Extension (NSE) software package. It provides remoteaccess to the Application Module or IPE Module from a PC using the telnetutility, and transfers files from a PC to the Application Module or IPEModule using the ftp utility.To activate the networking feature, Ethernet LAN support must have beenenabled using a keycode (refer to Procedure 25: Enable or disable EthernetLAN support).Note: Ensure that you have the Application Module or IPE Moduleconnected to the Ethernet with a cable before you run startNSE.Example:maint> startNSEEnter the Node Name: host1Enter the Node Address: 12.210.67.89Restart the system? yYou can choose to reboot the system at this point by typing y, or you candefer the reboot by typing n.stopNSE—de-activate Ethernet LAN supportThis command stops Ethernet LAN support and returns the system to itsoriginal status before NSE was started. It also prevents an Ethernet LAN-based PC from gaining access to the applications.Example:maint> stopNSERestart the system?You can choose to reboot the system at this point by typing y, or you candefer the reboot by typing n.
