Chapter 8: Recovery/replacement procedures 381Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance GuideProcedure 9: Configure the Application Module MVME167 SBC card orthe IPE Module (continued)Figure 34Environment prompts (IPE Module)Bug or System environment [B/S] = B? Field Service Menu Enable [Y/N] = N? Probe System for Supported I/O Controllers [Y/N] = Y? Local SCSI Bus Reset on Debugger Start-up [Y/N] = Y? Ignore CFGA Block on a Hard Disk Boot [Y/N] = Y? Auto Boot Enable [Y/N] = Y? Auto Boot at power-up only [Y/N] = N? Auto Boot Controller LUN = 00? . (Type a period (.) and press[Return].)Note: If you changed or reentered any values in Figure 34, you willsee two additional prompts, to which you should respond as shown inthe following figure.Figure 35Additional prompts (IPE Module)Update Non-Volatile RAM (Y/N)? y Reset Local System (CPU) (Y/N)? y The system reboots automatically. Messages start to appear on theconsole. If you want to reload the operating system, go toProcedure 20: Load the operating system tape on an IPE Module oran Application Module with an MVME167 card.The system automatically boots into the “Console Login:” prompt.The next time you reboot the system, it will no longer pause at the“167-Diag>” or “4120-Diag>” prompt.
