392 Chapter 8: Recovery/replacement procedures553-3211-510 Standard 1.0 October 1998Procedure 18: Replace or reconfigure the ApplicationModule MVME705B transition cardYou must remove the Application Module from the AEM to access thetransition cards.1 Complete Procedure 13: Remove the Application Module.2 Loosen the screws at the top and bottom of the card faceplate (atthe rear of the Application Module).3 Pull the card out of the Application Module.4 Disconnect the ribbon cable to the card.5 Check the jumpers and cable connections on the replacement cardor change the settings on the current card to reconfigure it. SeeTable 19 and Figure 39.6 Connect the ribbon cable to the replacement or reconfigured card.7 Slide the replacement or reconfigured card into the back of theApplication Module. Firmly press the middle of the faceplate to seatthe card.8 Install the screws on the faceplate of the card.9 Complete Procedure 14: Replace the Application Module, toreinstall the module.Table 19MVME705B jumper settings and cable connectionsSerialportDCE mode DTE modeSP1 On header K6, place jumpers overpins 3-4, 7-8, 9-10Plug the I/O cable into P14On header K6, place jumpers overpins 1-2, 5-6Plug the I/O cable into P13SP3 On header K5, place jumpers overpins 3-4, 7-8, 9-10Plug the I/O cable into P12On header K5, place jumpers overpins 1-2, 5-6Plug the I/O cable into P11SP5 Not used Not used