Nortel Meridian Meridian 1 Maintenance Manual

Also see for Meridian Meridian 1: Installation guide Implementation guide Scripting Guide Configuration manual Description

Contents

384 Chapter 8: Recovery/replacement procedures553-3211-510 Standard 1.0 October 1998Procedure 12: Replace the NT6D51 transition cardYou must remove the Application Module from the AEM to access thetransition cards.1 Complete Procedure 13: Remove the Application Module.2 Loosen the screws at the top and bottom of the card faceplate (atthe rear of the Application Module).3 Pull the card out of the Application Module.4 Disconnect the ribbon cable to the card.5 Connect the ribbon cable to the replacement card.6 Slide the replacement card into the back of the Application Module.Press hard in the middle of the faceplate to seat the card.7 Install the screws on the faceplate of the replacement card.8 Complete Procedure 14: Replace the Application Module, toreinstall the module.