378 Chapter 8: Recovery/replacement procedures553-3211-510 Standard 1.0 October 1998Procedure 9: Configure the Application Module MVME167SBC card or the IPE ModuleMVME167 cards and IPE Modules are shipped with auto-boot no-pausedisabled, which means that at boot time, it will pause at the “167-Diag>” or“4120-Diag>” prompt. The following configuration is necessary to enableauto-boot no-pause.ATTENTIONDo not press the [Backspace] or [Delete] key when the operatingsystem is not installed, or you may drop out of the procedure into aprevious menu or out of the installation procedure altogether. Use #(hold the [Shift] key and press 3) to backspace.If you drop out of the procedure (into the “#” prompt), start thereinstallation procedure from the beginning.This procedure assumes that you have completed Procedures 1 and 3, andyou have just installed a new IPE Module using Procedure 16 or a newMVME167 card in the Application Module using Procedure 7.1 Turn on the power (if it is not already on).If the “167-Diag>” or “4120-Diag>” prompt appears, go to step 4. Ifthe following messages appear on the console, go to step 2.Figure 30System restart messages (MVME167 card or IPE Module)Copyright Motorola Inc. 1988 - 1992, All Rights ReservedVME167 Debugger/Diagnostics Release Version 1.4 - 07/22/92COLD StartLocal Memory Found = 00800000 (&8388608)MPU Clock Speed = 25Mhz2 Before the messages start to appear, type h. If you are too late,press the Break key.