Chapter 8: Recovery/replacement procedures 423Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance GuideProcedure 20: Load the operating system tape on an IPE Module or anApplication Module with an MVME167 card (continued)Note: If your drive is not listed, but another drive of the same size islisted, use the option number for the listed drive. Although options 8,9, 16, and 17 start with the prefix “m147,” these options are alsoapplicable to IPE Modules and Application Modules with MVME167cards. If you experience difficulties, contact your local Nortel supportpersonnel.Disk types used Select this numberCDC ST1126N 9204 (104 Mbyte) 8CDC ST1201N (172 Mbyte) 9Fujitsu M2614S (180 Mbyte) 6Seagate ST3283N (240 Mbyte) 1620 For this example, the m147sea3283 disk drive is being used.Type 16 and press [Return].The system response is: “Selected the XXXX disk type”, whereXXXX represents the disk type selected.Figure 86Format disk drive promptSelected the ‘m147sea3283’ disk type.If the root file system’s disk is new or needs to be formatted,it can be formatted now. In order for you to take advantage ofdynamic disk slicing capabilities and the use of thesledit(1M) utility you may have to reformat the disk if itwas formatted with the R3V3 or earlier version ofthe BOS disk formatter, dinit(1M).WARNING - FORMATTING THE DISK WILL DESTROY ALL DATA ON THE DISK.---> Format the root file system’s disk drive (y, n, ?, q) [n]:21 You are prompted to format the root file system’s disk drive. Type yand press [Return] to indicate that you wish to format the drive.
