Chapter 8: Recovery/replacement procedures 407Meridian Link Release 5C/CCR Release 3C Diagnostic and Maintenance GuideProcedure 19: Load the operating system tape on an ApplicationModule with an MVME147 card (continued)26 You are prompted to enter the user file system slice number. Press[Return] to use the default slice number (2).Phase 2 of the BOS installation begins, and the slice table appears.Figures 59, 60, 61, and 62 show disk slicing tables for four differentdrive types.Figure 59Disk slicing table for 104-Mbyte disk drivePhase 2. Configure Root And Usr File-Systems And Swap AreaCheck the following slicing information for the root file system’s diskdrive; indicate below whether you wish to modify this information:slice offset sl size fs size fsname vol-id info0 648 40000 40000 root R3 11 40648 20000 0 1h82 60648 148484 148484 usr R3 13 0 0 0 1h84 0 0 0 1h85 0 0 0 1h86 0 0 0 1h87 0 209132 0 1h8---> Modify any of these parameters? (y, n, ?, q): [n]Figure 60Disk slicing table for 172-Mbyte disk drivePhase 2. Configure Root And Usr File-Systems And Swap AreaCheck the following slicing information for the root file system’s diskdrive; indicate below whether you wish to modify this information:slice offset sl size fs size fsname vol-id K0 648 60000 60000 root R3 11 60648 40000 0 12 100648 180000 180000 usr R3 13 280648 54827 0 14 0 0 0 15 0 0 0 16 0 0 0 17 0 335475 0 1---> Modify any of these parameters? (y, n, ?, q): [n]
