Notifier NFS-3030/E Programming Manual

Also see for NFS-3030/E: Installation manual Operation manual

Contents

Notifier NFS-3030/E Programming Manual Manual pdf 124 page image

Type Codes Type Codes for Input Devices124 NFS-3030 Programming Manual P/N 51345:C 11/4/03G.3 Type Codes for Input DevicesOverviewThis section provides a list of Type Codes for intelligent detectors and for monitor modules. Thefollowing Point Types light an LED at the panel when activated.•fire alarm - lights the FIRE ALARM LED•supervisory - lights the SUPERVISORY LED•security - lights the SECURITY LED•trouble - lights the TROUBLE LEDType Codes for Intelligent DetectorsFollowing is a list of intelligent detector Type Codes, which specify the type of detector installed atan SLC address.Appendix Table G-1 Intelligent Detector Type CodesPoint CharacteristicsType Code Point Type Latching(Y=yesN=no)ActivatesCBEDevice/Point FunctionSMOKE (ION) fire alarm Y Y Ionization smoke detectorSUP L(ION) supervisory Y Y Ionization smoke detectorSUP T(ION)** supervisory N Y Ionization smoke detectorSMOKE(DUCTI) fire alarm Y Y Duct Ionization smoke detectorSUP L(DUCTI) supervisory Y Y Duct ionization smoke detectorSUP T(DUCTI)** supervisory N Y Ionization smoke detector used as a duct detector to report supervisorycondition rather than alarm.SMOKE(PHOTO) fire alarm Y Y Photoelectric smoke detectorSUP L(PHOTO) supervisory Y Y Photoelectric smoke detectorSUP T(PHOTO) ** supervisroy N Y Photoelectric smoke detectorSMOKE(DUCTP) fire alarm Y Y Duct Photoelectric smoke detectorSUP L(DUCTP) supervisory Y Y Photoelectric smoke detector used as a duct detector to reportsupervisory condition rather than alarmSUP T(DUCTP)** supervisory N Y Photoelectric smoke detector used as a duct detector to reportsupervisory condition rather than alarm.RFSMOKE(PHOTO) fire alarm Y Y Wireless Photoelectric smoke detectorSMOKE(HARSH) fire alarm Y Y HARSH smoke detectorSMOKE(LASER) fire alarm Y Y Laser smoke detectorAIR REF fire alarm Y Y Assign to one or more FSL-751 detectors used to monitor the qualityof air entering the protected area. The air quality measurement allowsthe VIEW system to compensate for vehicle fumes, fog, or otherparticles brought into the protected area through the ventilation system.Poor air quality will lower the sensitivity of all FSL-751 detectors onthe SLC. The detector sensitivity, however, remains within approvedlimits (always less than 1% obscuration per foot).Note: A reference detector still functions as a smoke detector, but the detector sensitivity level should be set to the least sensitivelevel—AL:9 and PA:9 Alarm and Pre-Alarm sensitivity. Refer to “Detector Sensitivity Settings” on page 109 for a complete list ofdetector sensitivity settings.HEAT fire alarm Y Y 190 oF heat detectorHEAT+ fire alarm Y Y 190 oF heat detector with low temperature warningHEAT(FIXED) fire alarm Y Y 135 oF intelligent thermal sensorHEAT (ROR) fire alarm Y Y 15 oF per minute rate-of-rise detectorSMOKE ACCLIM fire alarm Y Y Combination Photoelectric/heat detectorSMOKE(ACCLI+) fire alarm Y Y Combination Photoelectric/heat detector with low temperature warningSMOKE(MULTI)* fire alarm Y Y Multisensor smoke detector* CLIP Mode only**Not suitable for Canadian applicationswww.PDF-Zoo.com