Control On/Off Point Select Alter StatusNFS-3030 Programming Manual P/N 51345:C 11/4/03 694.8 Control On/Off Point SelectThis screen may be used to force a control module (SLC or panel circuit) off if it is on, or on if it isoff.Figure 4.13 Control On/Off Point Select ScreenSoft KeysPOINT: Press this soft key to enter the point address to be forced on or off.Note: A module with a releasing Type ID cannot be forced.NEXT/PREVIOUS SELECTION: Press to progress to the next or previous point on the loop.ACCEPT: Press to continue to the Control On or Control Off screen.4.8.1 Control OffOne of the following two screens will display when a point is selected and accepted in the previousscreen.If the selected point is active, the Control Off screen will appear.Figure 4.14 Control Off ScreenSoft KeysFORCE OFF: Press this soft key to change the state of the control module from A U T O M A T I CL A K E V I E W G E N E R A L H O S P I T A LS Y S T E M N O R M A L1 0 : 2 2 : 3 4 A F R I J A N 2 5 , 2 0 0 2P O I N T S E L E C TP O I N T : L y y M z z z ( M O D U L E )N E X T S E L E C T I O N A C C E P TP R E V I O U S S E L E C T I O N B A C KL A K E V I E W G E N E R A L H O S P I T A LS Y S T E M N O R M A L1 0 : 2 2 : 3 4 A F R I J A N 2 5 , 2 0 0 2C O N T R O L O N / O F F : L 0 3 M 0 5 2A U T O M A T I C A C T I V EE L E V A T O R R E C A L L E A S T W I N GF I F T H F L O O R Z 0 0 0 C O N T R O LF O R C E O F F B A C Kwww.PDF-Zoo.com
