Section 7 COPIER MANAGEMENT7-21& Custom erase size1 Press the O cursor or the P cursor key to select the lengthof the original to be used in the custom erase mode.(The length can be set to any 5/16" increment between3 11/16 " and 8 7/16 " [any 8 mm increment between 94 mm and214 mm.])Inch specificationsMetric specifications2 Press the N cursor key to change to the width size setting.3 Press the O cursor or the P cursor key to select the paperwidth. (The length can be set to any 1/8" increment between2 3/8 " and 11 5/8 " [any 4 mm increment between 60 mm and296 mm.])Inch specificationsMetric specifications4 Press the Enter key.* Insert tray1 Use the M cursor or the N cursor key to select the drawerthat contains the paper which will be fed in the insert sheetmodes.* The “1 paper” [“SOURCE 1”] drawer is not available induplex copiers.Inch specificationsMetric specifications2 Press the Enter key.( Sort mode ON/OFF (Output form)1 Use the M cursor or the N cursor key to select either“z On” or “x Off”.Inch specificationsMetric specifications2 Press the Enter key.