Section 9 TROUBLESHOOTING9-42. If paper jamsIf a paper misfeed occurs, copying will stop. A message will appear about the misfeed and the location of the misfeed will be indicated on theoperation panel. Leave the main switch ON ( | ) and refer to “(3) Removal procedures” on page 9-5 to remove the jammed paper.16824537(1) Misfeed location indicators1 Misfeed in the paper feed area (page 9-5)2 Misfeed in the paper conveyor section (page 9-7)3 Misfeed in the transfer section (page 9-8)4 Misfeed in the fixing section (page 9-10)5 Misfeed inside the left cover or near the copy storage table(page 9-12)6 Misfeed in the Duplex Unit (Only in duplex copiers) (page 9-13)7 Misfeed in the optional SRDF (page 9-14)8 Misfeed in the optional Document Finisher (page 9-15)(2) Cautions* Do not reuse misfed paper.* If paper is torn during removal, be sure to remove any loose scrapsof paper from inside the copier, or they could cause another misfeedlater.* Once misfed paper has been removed, warm-up will begin, themisfeed message will disappear, and the copier will return to thesame settings prior to the misfeed.* If a misfeed occurs in the optional Document Finisher, it is notnecessary to add the misfed copy to the other copies in theDocument Finisher tray, as that copy will be automatically madeagain.WARNINGHigh voltage is present in the charger section. Takesufficient care when working in this area, as there isa danger of electrical shock.CAUTIONThe copier’s fixing unit is extremely hot. Takesufficient care when working in this area, as there isa danger of getting burned.