Section 8 OPTIONAL EQUIPMENT8-3 Setting originals on the platenWhen copying from an original which cannot be set in the SRDF(books, magazines, etc.), lift open the SRDF and set the originaldirectly on the platen.1 Operate the SRDF release lever and open the SRDF.* Before opening the SRDF, make sure that there are nooriginals remaining on the original eject table. If there areoriginals left on the eject table, they will fall off the copierwhen the SRDF is opened.2 Set the original to be copied face-down and align the edgeswith the original size indicator lines.3 Hold the SRDF release lever and close the SRDF.IMPORTANT!Do NOT put undue pressure on the SRDF when you close it or thereis a chance that you might break the platen glass. Auto selection modeIf you use the auto selection mode without pressing the Paper Selectkey and specifying a desired paper size, originals will be checked onby one for their size and the appropriate copy exposure, and paper ofthe same size as each original will be selected automatically.* You can set up to 30 originals in the SRDF in this mode.* Only originals with the same width, such as 11" x 17" and 11" x 8 1/2 "[A3 and A4] size originals can be used in this mode.• Selecting the auto selection mode1 Press the Auto Selection/Filing key to light the correspondingindicator.The “Select function” screen will appear.2 Make sure that “z Auto select” [“z AUTO SEL.”] is selectedand press the Enter key.The message display will return to the “Ready to copy.”screen.Inch specifications Metric specificationsCAUTIONDO NOT leave the document feeder open as there isa danger of personal injury.
