136 Chapter 8 Maintain the Océ TCS300 printerReplace the medialower softkey and select 'More...'. Then a list displays of all the media types that youcan select.2. Press the key for 'Next' to enter the cut option screen. The system displays thequestion 'Cut?'3. Use the lower softkeys to select the cut option for the media.[76][76] Select the cut optionSelect one of the following.■ 'Yes, long strip'Cut the media with a full roll rotation feed (50 cm) before the printer cuts themedia. You can use this option when the media is damaged or polluted with, forexample, tape residue.■ 'Yes, short strip'Cut the media with the shortest possible strip (20 cm).■ 'No'No media cut.4. Press the key for 'Finish' to confirm the settings and to exit the wizard.How to correct the media type defined on the systemAttention: You need only to correct the type of media when an incorrect mediatype was defined when the roll was loaded.When you define a type of media that is different from the media type loaded onthe system, the print quality decreases and pollution of the system can occur.
