145Replace a defective printhead[87]9. Pull out the printhead and remove it.[88]How to place a printhead1. Remove the protective tape from the new printhead.Note: Do not touch the contact and nozzle areas of the printhead after you removethe protective tape.2. Place the new printhead in the printhead holder.The printhead only fits in one way.3. Close the printhead cover.4. After you replaced the defective printhead, press the softkey for 'Next'5. The screen displays the message 'Make sure that all head covers are properlypositioned.'Press the key for 'Done'.The screen displays the message 'Close top cover.'6. Close the top cover.The screen displays the message 'Carriage moving to home position...'7. The screen displays 'Calibrating...'.The calibration process takes several minutes.You can stop the calibration process at any time. Press the key for 'Cancel' to stop thecalibration process.
