48 Chapter 3 Prepare the Océ TCS300 for useConfigure the network settings of the Océ TCS300Configure the network settings of the Océ TCS300IntroductionThe system administrator is responsible for installing and configuring the OcéTCS300 in the network environment. There are two ways to configure the networksettings.■ From the printer operator panelThe off-line screen on the printer operator panel contains a wizard to configurethe network settings.■ With the System Administrator settings in the Océ Settings Editor.The Océ Settings Editor allows you to configure a large number of systemsettings. The system administrator and the power user are authorised to define thesystem settings.Actions in the Configure system wizardYou can perform the following actions in the 'Configure system' wizard.■ Enable DHCP■ Set the IP address■ Set the IP subnet mask■ Set the default gateway■ Configure the DNS settings■ Configure the primary and secondary WINS■ Clear the set memory. (see ‘Clear the set memory’ on page 161).The 'Configure system' wizard also contains installation settings and servicesettings. A password protects the installation settings and the service settings. OnlyOcé service engineers can access the installation settings and the service settings.How to configure the system from the printer operator panel1. Press the on-line / off-line key to set the printer off-line (see ‘The on-line mode andthe off-line mode’ on page 26).2. Use the upper softkeys to scroll to the 'Configure system' card.[34]3. Press the softkey below the 'Configure system' card to enter the wizard.The screen displays the message 'Use this wizard to configure the system.'
