51Configure the network settings of the Océ TCS300[40]16. The final dialogue allows you to define a password protection for the 'Configuresystem' wizard. You can enable the password protection to prevent accidentalchanges in the configuration of the system.The password is fixed and cannot be changed. Use the lower left (= a) and right (=b) soft keys of the operator panel to enter the password: abbab. When thepassword-protection is enabled, you must enter this password the next time you wantto edit the network settings. You can disable the password protection again at the endof the 'Configure system' wizard.17. Press the key 'Apply' to confirm the settings and to exit the wizard.The system indicates whether you have to restart the Océ Power Logic® controllerto apply the new network settings. This can, for example, be the case when settingsare received through DHCP. When no indication appears, you do not need to rebootthe Océ Power Logic® controller.Note: When 'Synchronise controller power on / off' is set to 'On', you must turn theprinter off and on to restart the Océ Power Logic ® controller.How to configure the network settings in the Océ TCS300 Settings Editor1. Click 'Configuration' - 'Network'- 'TCP/IP'.You can expand or collapse the settings that belong to the 'TCP/IP' group. Theexpanded view displays all the settings and the values that are currently active.2. Click 'Edit' in the group bar to access the 'Edit' window. You can edit all the settingsof the 'TCP/IP' group in one window.or3. To edit only one setting in the 'TCP/IP' group, click a single setting value in theexpanded list.Note: Log on as System administrator or Power user in the Settings Editor.For example, click 'Enable DHCP' to display a window where you can change thesetting.Note: This window also contains a short explanation of the setting.4. Click 'Ok' to confirm you entries or 'Cancel' to reject your entries.
