44871001TH Rev.6 4-31Oki Data CONFIDENTIAL4.REPLACEMENT OF PARTSHookFFC cableHolder-Head4.2.10 LED Head(1) Open the Stacker Cover.(2) Remove the ID UNIT.(3) Disengage the tab of the Holder-Head from the stacker cover by using a flat-headscrewdriver or something.(4) Pull the Holder-Head toward you as illustrated below.(5) Open the Holder-Head by arrow direction and then remove the hook. remove theLED Head .(6) Remove the FFC cable from the connector of LED Head .(7) Installing is performed by the reverse procedure with removing.Note! Beware of not to touch or press the SLA parts of LED Head directly.4.2.11 Frame-Assy-TR(1) Open the Stacker Cover.(2) Remove the ID UNIT.(3) Take the Frame-Assy-TR out of the printer.(4) Disengage the latches of Bearing-TR on both ends.(5) Hold the Bearing-TR on the both side, and then lift up the Roller-Transfer .(At this moment, Gear-TR is also removed.)(6) Installing is performed by the inverse procedure with removing.Note! (to assemble)1. While installing, pay attention to the up-and-down direction of Bearing-TR .2. Operating carefully, not to touch Roller-Transfer surface.3. Be careful not to fit each Bearing-TR to the Frame-Assy-TR with their springsinclined.Frame-Assy-TRSpringLatchSpring
