Oki Data CONFIDENTIAL 6. MAINTENANCE MENUS44871001TH Rev.6 6-26.1 Maintenance MenuNote! The initial Password is set to "000000" (six zeros).Item1 Item2 Item3 Item4 Item5 ValueDefaultvalueODADefaultvalueOELDefaultvalueJPNotesPassword ************ Enter the password for accessing the maintenance menu.6 to 12 characters (numerals and lower-case alphabetic characters) may be entered.SystemMainte-nanceOKIUSER*MPS mode:MPS. Notshown duringmaintenance.ODAOELAPSJP1JPOEM1OEMAOEMLSet the destination.JPOEM1 : OEM for JapanOEMA : OEM for overseas, with A4 as default sizeOEML : OEM for overseas, with Letter as default sizeDevice reboots automatically after exiting the menu.Displayed under the following conditions:"However, operation when JP1/JPOEM/OEMA/OEML is chosen is not guaranteed.The display condition of the menu is following two.① "System Maintenance" - "When "OKIUSER" is other than JPOEM1, OEMA orOEML② "Manufacturer" is "OKI DATA CORP".Format SDMemory Card*Shown onlywhen anSD card isconnectedExecute Formats the SD card.A confirmation message is displayed when the Enter switch is pressed.When "No" has been selected, the system returns to the previous menu. When"Yes" has been selected, the menu is exited and formatting of the inserted SD cardbegins.Displayed under the following conditions:SD card inserted ("Boot Menu" - "Storage Setup" - "Enable SD Card" is Yes)Format FlashMemoryExecute Formats flash ROM memory.When this command is executed, the menu is exited and formatting of the resident(onboard) flash device begins.Use of this command is strictly prohibited (contact design before use)Reset AdminPasswordExecute Returns the administrator password to the factory default value.All Reset*MPS mode:MPS. Notshown duringmaintenance.Execute Returns the content of EEPROM, flash, and the HDD to their factory default values.When this command is executed, the following confirmation message is displayed:"This change will reboot the device automatically. Proceed?"When "No" has been selected, the system returns to the previous menu. When"Yes" has been selected, the menu is exited immediately and then, after rebooting,reset processing begins.See the "format scope" sheet for the scope of formatting.Service MenuWhen the equipment is in standby mode, access the password entry screen by pressing [Setting] → [#] → [0] → [1] → [0] → [3] → [*].
