Oki Data CONFIDENTIAL44871001TH Rev.6 6-216. MAINTENANCE MENUS6.4.2.5 Test printThis self-diagnostic menu is used to print the test pattern that is built inside PU. Other testpatterns are stored in the controller.This test print cannot be used to check the print quality.Diagnosis for the abnormal print image should be performed in accordance with section 6.1. Enter the self-diagnostic mode (level 1), press the [2] or [8] key repeatedly ,andpress the [OK] key when the "TEST PRINT" is displayed in the upper row of thedisplay area. (Pressing the [2] key increments the test item and pressing the [8 keydecrements the test item.)2. The setting items that can be applied to the test print only is displayed in the lowerrow of display area. Keep pressing the [2], [8] key until the desired menu item isdisplayed. (Pressing the [2] key increments the test item and pressing the [8] keydecrements the test item.) (If all setting items need no entry [Default setting], go tostep 5.)3. Keep pressing the [2], [8] key, and press the [6] key at the menu item set by step 2.Then, the setting item is displayed in the upper row of display area, and the settingvalue is displayed in the lower row of display area.Pressing the [2] key increments the setting value. Pressing the [8] key decrementsthe setting value. (The setting value that is displayed at last is applied.) Pressing the[4] key determines the entry value, and returns to step 2. Repeat step 3 as required.TEST PATTERN1Display SettingvalueFunctionPRINT EXECUTE – Pressing the [6] key starts print/Pressing the[#] key terminates print. (In units of page)TEST PATTERN 0 0: White paper print1~7: Refer to next page. (Pattern print)8~15: White paper printTEST CASSETTE TRAY1 Selecting source of paper supply.If the TRAY 2 is not installed, TRAY2 is notdisplayed.TRAY2MPTPAGE 0000 Setting number of the test print copiesDUPLEX OFF Selecting OFF for duplex (2-sided) print.Duplex (1-sided) print is performed by thestack of one sheet of paper.1 PAGESSTACK• is the initial default value. The menu item that is set here is valid in this menuitem only.(The setting item is not saved in EEPROM.)Note! PAGE settingPressing the [2] key or the [8] key shifts the digit. Pressing the [ ] keyincrements the setting value. Pressing the [#] key decrements the settingvalue. If print is executed while the number of print copies remains in"0000", printing will continue infinitely.
