Panasonic AJ-D455 Operating Instructions Manual

Also see for AJ-D455: Menu information

31USER menuItem SettingNo. Superimposed No. Superimposed Descriptiondisplay display500 VITC 0000 10L. .. .POS-1 . .0006 16L. .. .. .0010 20L501 VITC 0000 10L. .. .POS-2 . .0008 18L. .. .. .0010 20L502 VITC 0000 BLANKBLANK 0001 THRU503 TCG 0000 TC&UBREGEN 0001 TC0002 UB504 REGEN 0000 OFFMODE 0001 ON505 EXT TC 0000 LTCSEL 0001 VITC506 BINARY 0000 000GP 0001 0010002 0100003 0110004 1000005 1010006 1100007 111507 PHASE 0000 OFFCORR 0001 ON508 TCG CF 0000 OFFFLAG 0001 ONThe underline on the setting item denotes the initial setting.This sets the position where the VITC signal is to be inserted.(The same line as for VITC POS-2 in 501 cannot beselected.)This sets the position where the VITC signal is to be inserted.(The same line as for VITC POS-1 in 500 cannot beselected.)This selects whether to output the VITC data to the positionsselected by VITC POS-1 in 500 and VITC POS-2 in 501.0: Data is not output.1: Data is output.This selects the signal to be regenerated when the time codegenerator (TCG) in the REGEN mode.0: Both the time code and user bit are regenerated.1: Only the time code is regenerated.2: Only the user bit is regenerated.This selects whether values used in the internal time codegenerator are preset from the front panel or remote controlleror synchronized with time code values read from the tape.0: Values are preset from the front panel or remote controller.(PRESET)1: Values are synchronized with time code values read fromthe tape. (REGEN)When “1” is selected, values selected at set up menu No. 503(TCG REGEN) are regenerated.This selects the time code to be used when an external timecode is to be used.0: The LTC of the TIME CODE IN connector is used.1: The video signal VITC is used.This sets the usage status of the user bit of the time codegenerated by the TCG.0: NOT SPECIFIED (character set not specified)1: ISO CHARACTER (8 bits character set based on ISO646,ISO2022)2: UNASSIGNED 1 (undefined)3: UNASSIGNED 2 (undefined)4: UNASSIGNED 3 (undefined)5: PAGE/LINE6: UNASSIGNED 4 (undefined)7: UNASSIGNED 5 (undefined)This selects whether to control the phase correction of theLTC generated by the TCG.0: Phase correction control is not performed.1: Phase correction control is performed.This selects whether the CF flag of the TCG is to ON.0: CF flag is OFF.1: CF flag is ON.