Panasonic AJ-D455 Operating Instructions Manual

Also see for AJ-D455: Menu information

43Rack mountingThe unit can be mounted into a 19-inch standard rack if the optional rack-mounting adaptors(AJ-MA75P) are used. For the installation rails, it is recommended that the rail and bracketfor 18" length (model number CC3061-99-0400) of Chassis Trak be used. (The completeslide rail and bracket unit is not available from Panasonic.) For further details, consult withyour dealer.1 Refer to below for the places where they are to be secured with the screws.A B C D E F G H Attach the inner members at thesame symmetrical positions on theleft (L) side.Note: The letters “A” to “H” are notactually marked on the sidepanels.Inner memberLocations where the screws are secured on right (R)side of inner members of slide railsThe length of the screws used is subject to restriction. Use screws which are less than2/5" long in their place.6 screws must be used to secure each inner member.2 Attach the outer member brackets to the rack.Check that the height is the same for the left and right brackets.3 Remove the four screws at the front for attaching the left and right side panels.4 Attach the AJ-MA75P rack mount adapter using the 4 screws included.Rack-mounting adaptors5 Remove the 4 rubber legs from the bottom of the unit, and install the unit in the rack.After the unit has been installed, check that it moves smoothly along the rails.Fasten it to therack with setscrews.EIA standard rack• Keep the temperature inside the rack to between +41°F (5°C) and +104°F (40°C).• Bolt the rack securely to the floor so that it will not topple over when the VTR is drawn out.