46Error messagesDisplaying the “HOURS METER” informationPress the cursor buttons ( , ) to move the cursor ( ∗ ).The number for the item where the cursor is located is shown on the counter display.Item No. Item DescriptionH00 OPERATIONH01 DRUM RUNH02 TAPE RUNH03 THREADINGH11 DRUM RUN rH12 TAPE RUN rH13 THREADING rH30 POWER ONThe resettable items in the “HOURS METER” information are reset by the service personnel when performingmaintenance or other work.If T&S&M is selected in the setup menu No. 003 (DISPLAY SEL), a message appears in the mode displaywhenever a warning or error occurs. When multiple events occur, the event with the highest priority is displayed.Counter display andPriority monitor display DescriptionHigh Error messages(See error message table)INT SGNO INPUTWarning messages(See warning messageLow table)Displays the time that the power has been supplied in one-hour units.Displays the time that the drum has been rotating in one-hour units.Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) inone-hour units.Displays the number of times for threading/unthreading in single units.Displays the time that the drum has been rotating in one-hour units. (Can be reset)Displays the time that the tape has been running during FF, REW, PLAY, SEARCH (JOG,VAR, SHTL), REC, and EDIT modes (except for STILL in the JOG, VAR or SHTL mode) inone-hour units. (Can be reset)Displays the number of times for threading/unthreading in single units. (Can be reset)This displays the number of power-on times with one power-on counting as one time.When an abnormal operation is detected in this machine, an error number flasheson the counter display and an error message is displayed.If “BB” or “CB” in No. 601 (INT SG) in the setup menu is selected, pressing the RECbutton (E to E mode) will display “INT SG” for the first two seconds. This is alsodisplayed for the first two seconds when starting editing from the external controller.If there is no input signal (except for analog audio) to the connector selected usingthe VIDEO INPUT switch, pressing the REC button (E to E mode) will display “NOINPUT” for the first two seconds. This is also displayed for the first two secondswhen starting editing from the external controller.When a warning occurs in this unit, an error number appears at the counter displayand warning message is displayed. When multiple warnings occur, the warning withthe highest priority is displayed.
