9@3 Volume controlThis is used to adjust the headphones volume.@4 Audio recording level controls*These are used to adjust the recording levels of the audio signal CH1/CH2.@5 SUPER ON/OFF switchON: The time code or other display is superimposed onto the signals supplied to theVIDEO OUT 3 connector.OFF: No display is superimposed.• When the AJ-YA455P is used, the superimposed display appears at the VIDEO OUT 3connector.• When the SUPER ON/OFF switch is set to ON, the EDH of the SDI OUT 3 connector isnot superimposed.@6 MONITOR SELECT switchThis is used to select the audio signals output to the monitor channel.@7 INT/EXT switchINT: For using the built-in time code generator.EXT: For using the time external code which is input from the time code input connector orthe video signal VITC. The selection is set at the setup menu.@8 MENU buttonWhen this is pressed, the setup menu appears on the TV monitor using VIDEO OUT 3connector, and the setup menu No. appears on the display.When it is pressed again, the setup mode is exited and the original operating mode isrestored.@9 TC PRESET (FILE) buttonThe time code setting mode is established by pressing this button. (For details, refer to thetime code section on page 39.)User file can be selected when the cursor buttons ( , ) are used during the setupmenu mode. (For details, see setup menu items on page 16.)#0 Cursor buttons ( , , , )These are used when setting time codes and settings at menu setup., : These change the flashing digit in the time code indicators.Each time they are pressed, the flashing indicator moves incremently to the left orright.increments to the left; increments to the right., : These change the flashing digit in the time code indicators.Each time they are pressed, the indicated value increments and decrements.decrements the value; increments the value.The flashing digit changes continuously when the button is continuously pressed.For details about operation during setup menu mode, see setup menu items (page 15).#1 SET buttonThe time code is set or the data selected for the setup menu settings are entered bypressing this button.After the data has been entered, the setup mode is exited, and operation returns to theoriginal mode.* The recording level of the audio signals cannot be adjusted when DVCPRO/DV has beenselected by the VIDEO INPUT switch #3.
