270 DBS 576 (USA), issued January 1999 576-20-700Chapter 7. SLT Features Section 700 - OperationTo cancel an Absence MessageRelated Programming• FF1 (System): Extension Class of Service Setting• FF3 (Extension): Extension Class of Service Assignment• FF8 (Maintenance): Absence MessagesConsiderations• Calling parties without a display get a busy signal, rather than the Absence Message.• Regardless of setting an Absence Message on a DID/DIL extension, DID/DIL calls are routedaccording to the trunk ringing setting.• An absence message may also be cancelled by dialing 7**. This cancels Do Not Disturb and CallForwarding-All Calls as well.Account CodesCPC-96, CPC-288, and CPC-576 All VersionsDescriptionYou can assign account codes to clients to facilitate billing and to track call dates and times, numberscalled, and outside line numbers used. This information is printed for each account on the SystemMessage Detail Recording (SMDR) record.In addition verified account codes may be used to change the TRS level to allow calls to numbersotherwise restricted.Account codes may be either forced or unforced (voluntary) and either verified or unverified.This feature works with Station Message Detail Recording (SMDR). Before making an outgoing call,a station user can silently enter an accounting or client billing code. Then later, the SMDR reports willshow the Code dialed for each call, and even sort the report by these Codes.There are two different types of account codes you can use in the DBS 576:Non-Verified Account CodesNon-Verified Codes aren’t checked by the system for validity; the user can enter anything from 1-10digits long. Individual phones can be programmed to accept forced Account Codes (the user mustenter a code for every call) or voluntary Account Codes (the user can enter a code, but doesn’t haveto, for each call).Non-Verified Account Codes can be assigned to outgoing calls. The user either enters the Code beforeaccessing an outside line (for forced or voluntary Codes).Action Result1. Lift the handset. Intercom dial tone2. Enter the Absence Message code (default = 729).3. Flash the hookswitch.4. Replace the handset.
