96 DBS 576 (USA), issued January 1999 576-20-700Chapter 4. User Maintenance Section 700 - OperationSet Mode ScheduleDescription(For a description of Automatic Day/Night System Mode, see “Automatic Day/Night Mode” on page42.)You can set the System to automatically enter None, Day 1, Day 2, Night, Night (1), or Night (2)modes based upon mode patterns. You can define up to 3 patterns with up to 5 modes for each day.(This menu allows the setting of the patterns.)OperationTo set the Mode Schedule:Action Result1. If not already in User Maintenance mode, enter User Main-tenance mode. (See “To enter User Maintenance mode:” onpage 79.)81-User MAINT displays2. At the 81 level, enter 07.3. Press the HOLD key. 8107-System Mode displays4. Press the HOLD key. 0-Mode Schedule displays5. Press the HOLD key. 000 :HHMMPTN 1-1 Start T displays6. Enter the start time in hours (two characters) and minutes(two characters) for the Pattern 1 - first mode.Note: To clear an entry or existing data, press the FLASHkey.7. Press the HOLD key. 001 :PTN 1-1 Mode displays8. Enter the desired mode for Pattern 1 - first (0 - None, 1 -Day 1, 2 - Day 2, 3 - Night, 4 - Night (1), 5 - Night (2)).Note: To clear an entry or existing data, press the FLASHkey.9. Press the HOLD key to store the entry. Next pattern mode displays10. To set additional mode schedules, press the volume up ordown key or press the HOLD key to move to the desiredmode.Desired pattern mode displays11. Repeat steps 6-10 until all patterns and modes are set.(There are 3 total patterns with 5 start time/modes each.)Note: Entry Positions are listed in Table 10 on page 97.
