SYSTEM MAINTENANCE AND TROUBLESHOOTING132 Installation Manual7.2.17 Quick Setup (QSET)This command is initially used to perform a basic setup of your VPS when you use your VPSfor the first time or after system initialisation.NoteQuick setup requires VT100 emulation software.Type QSET, then Press RETURN.7.2.18 Circuit Condition Display (LMON)This command is used to display the circuit condition every 1.5 s. The command can be turnedoff by entering [\].The following circuit conditions may be displayed.7.2.19 Touchtone Information Display (PUTD)This command is used to display the touchtones the VPS receives and sends.In addition to the touchtones the following are displayed — the Incoming Call Service (VoiceMail, Automated Attendant, Custom, and Interview) entered by the caller and the time periodsthat the ports are enabled.Type PUTD. The VPS will remain in this mode until "PUTD" is entered again. The defaultsetting for this mode for all ports is "OFF.""Ready""Incoming Call Service""Outgoing Call Service""DSP Reset Processing""PT connect Processing""Error/Not Exist": Waiting for a call: Answering a call: Making an outbound call: Processing DSP reset: Processing PT connect: DSP Card is not loaded$ LMONCO No.:1: Ready2: ReadyStatus$ PUTDTarget Port : * *$
