SYSTEM ADMINISTRATOR'S GUIDE244 Installation ManualB7.2 Port SettingPort Setting MenuNoteThe port assignment procedure for Port 2 is the same as Port 1.To select Port Setting, follow the menu path as shown:System Administration Top Menu - 1 - 6 - 2To select the Port Setting Menu for Port 1, follow the menu path as shown:System Administration Top Menu - 1 - 6 - 2 - 1Table 69Parameter Value Range(Default)Description/FunctionFlash Time 1. 100 ms(100)Specifies the duration of the flash (recall) signal that theVPS will send to the PBX.CPC Signal 1. None2. 6.5 ms3. 150 ms4. 300 ms5. 450 ms6. 600 ms(6.5)Specifies the minimum time necessary to detect aninterruption in the CPC (Calling Party Control) signalreceived from the PBX. The VPS is able to determinethat the line has been disconnected when aninterruption of the CPC signal has been detected.DisconnectTime1-8 s(2)Specifies the length of time the line is temporarilyunavailable after a call has ended.Dial Mode 1. DTMF2. Pulse 10 pps3. Pulse 20 pps(DTMF)Specifies the dial mode for DTMF (touchtone) or Pulse.If Pulse is specified, pulse speed (10/20 pps) must beselected.Note: This setting only affects outward dialling fromthe VPS. The VPS can only receive DTMF (touchtone)signals.
