1263-6 Laser Setting3-6-1 Screen for Laser SettingThe condition of the marking laser for marking a character string or CAD file is set on this screen.The “Laser Setting” dialog box is appeared by clicking either selecting “1” method or clicking “2” buttondescribed above.1 “View” - “Set Laser”2 Click .Item Description Setting Range1. Laser Power Sets the average output of the marking laser. 0.5 to 100.0 (Step: 0.5)2. Scan Speed Sets max. transfer speed of the laser spot. 1 to 2000mm/s (Step: 1mm)3. Line Width Sets the with of the stroke of the marked character. 0.01 to 2.00mm (Step: 0.01mm)4. Start Wait Adjusts the timing for turning ON the laser at thestart point.50 to 150 (Step: 1)5. End Wait Adjusts the timing for turning OFF the laser at theending point.50 to 150 (Step: 1)6. Marking Pitch Sets the density for marking a bold character. 0.00 to 2.00mm (Step: 0.01mm)7. Marking Quality Sets the number of segments of the stroke at acurve part stepwise.Rough to fine11 steps• Even if the scan speed is doubled, the marking time is not reduced to a half.• If the scan speed is too high, the characters may be distorted. Check the symptom at the testmarking beforehand.1234567CHECK
