472-1-1 Preparation of Laser Marker OperationCheck the package.Check the package referring to “1-1 Package Check” (P.32).If something is lack, as for the nearest sales office.Install the laser marker.Install the laser marker referring to “1-3 Installation” (P.36).Install “LP-300 series PC Setting Software” stored in the attached CD-ROM to thePC.Refer to the “Installation Manual” for the procedures.Connect the laser marker.Connect the laser marker referring to “1-4 Connecting Laser Marker” (P.40).To operate this laser marker, connect the following signals on I/O connector. For the details, refer to“4-1-2 I/O Connector” (P.157).• Connect the power supply to [IN COM.] (pin No.14) and to [OUT COM.] (pin No.15) respec-tively.• Connect [LASER STOP] (pin No.4) and [OUT COM.] (pin No.15) to release the erroneous irra-diation prevention function for the laser.HeadPower Supply BOXHead Power Cable (5m)AC Power Cable (3m)To POWERTo InletTo Interlock SystemUSB Cable (5m)To Interlock ConnectorWiring of I/OCHECK2314
