1624-1-6 Input/Output Operation■ I/O Connector Input SignalTerminal No. 14: Input Common (IN COM.)• This is the terminal for input common. Connect this terminal to the “+” (plus) side of the control powersupply for NPN connection, and connect this terminal to the “-” (minus) side of the control power supplyfor PNP connection.Terminal No. 3: Trigger Input (TRIG.IN)• This is the terminal of marking start signal. When the marking ready output is ON, the marking is startedon the edge of the trigger input ON signal.Input TRIG. IN with holding the input status of the file selection (D0 to D6). (When the file No. changingcommand (FNO) is set by RS-232C, input of D0 to D6 is not required.)Terminal No. 4: Laser Radiation Stop Input (LASER STOP)• This is the input terminal for stopping laser radiation. It is connected to the switch of the manual door ofthe device.When setting the state between the laser radiation stop input and terminal No. 15 OUT COM. into OPEN,the laser radiation is stopped.(When setting this state into OPEN during marking, the laser pumping is stopped. When setting this stateinto OPEN during non-marking, the marking ready output becomes OFF.)Terminal No. 17: Counter Reset Input (COUNTER RESET)• This terminal sets the input to ON when resetting the counter.Input COUNTER RESET with holding the input status of the file selection (D0 to D6).(When the file No. changing command (FNO) is set by RS-232C, input of D0 to D6 is not required.)Terminal No. 5, 6, 7, 8, 18, 19, 20: File Select Input (D0 to D6)• These terminals select the file No. to be transferred into the head.Specify the file No. (1 to 120) with D0 to D6. The file No. is specified with binary digit, and is selected byON/OFF.Keep the input status of D0 to D6 while using the selected file.The “File No.” correspondence table is as follows.* The selectable file Nos. are from 1 to 120.File No. File No. in binary formD6 D5 D4 D3 D2 D1 D0001 0 0 0 0 0 0 1002 0 0 0 0 0 1 0003 0 0 0 0 0 1 1004 0 0 0 0 1 0 0005 0 0 0 0 1 0 1006 0 0 0 0 1 1 0007 0 0 0 0 1 1 1008 0 0 0 1 0 0 0••• •••118 1 1 1 0 1 1 0119 1 1 1 0 1 1 1120 1 1 1 1 0 0 0
