1594-1-3 Signal Name and Content of I/O ConnectorTerminalNo. Display Name Description14 IN COM. Input common Common for input3 TRIG. IN Trigger inputStarts marking on the edge of the input ON.Input TRIG. IN with holding the input status of the fileselection (D0 to D6).4 LASER STOP Laser radiation stopinputWhen setting the states of both I/O connector s No. 4LASER STOP and No. 15 OUT COM. to OPEN, thelaser radiation is stopped. For marking, short-circuit theterminals No. 4 and No. 15.17 COUNTERRESET Counter reset inputSets this terminal ON for resetting the counter.Input COUNTER RESET with holding the input status ofthe file selection (D0 to D6).5 D0File select inputThese terminals are used for switching the file No. 1 toNo. 120 saved in the head. Keep the input status of D0to D6 while using the selected file.18 D16 D219 D37 D420 D58 D615 OUT COM. Output common Common for output16 READY Marking ready output When the marking is ready for starting (in TRIG.IN inputreceivable state), the output becomes ON.25 COUNTER END Counter reset output When the counter reaches to the ending value, the outputcomes ON.13 ALARM Alarm outputWhen an alarm is occurred, the output becomes OFF.The content of the alarm is displayed with error code inthe head display panel.1 +12V Power supply forexternal device +12V +12V DC power supply for external device. (100mA Max.)2 0V Power supply forexternal device 0VGround for the power supply for external device (commonto the inside)9Reserved System reserve Do not connect anything to the external devices.10111221222324InputOutputPowerRESERVE
