1273-6-2 Line WidthThe line width is the setting value for creating the clearance at the intersection of the character strokes.The initial value of the line width is set so that the character strokes are not overlapped at the intersection inthe case of general marking.However, if the initial value is applied to the actual character marking, the character strokes may be over-lapped each other so that the character is engraved too deeply or characters strokes are so apart that clear-ance is created.In such cases, overlay at the intersection can be adjusted finely by changing the setting of the line width.Setting Range: 0.01 to 2.00mmInitial Value : 0.20mm3-6-3 Marking PitchThis item sets the density of the marking of the bold character.• Marking bold charactersEven if the setting for the line width is adjusted, the width of the character stroke being marked isnot changed.• The setting value of the “line width” is differed from the width of the actual marked strokesdepending on the material of the work being marked. For marking with proper “line width” and“line width of bold character”, it is recommended to measure the line width of the marked onestroke, and then input the proper setting value of the “line width”.• This correction is not effective for the CAD data.Too large line width Proper Too small line widthLineWidth LineWidth LineWidthCHECKMarking pitch Marking pitchLine widthof boldcharactersLine widthof boldcharactersCHECK
