Using the remote control38 - ENGLISHBasic OperationNotezThe signal displayed for the button andthe button changes depending on thetype of input module inserted.zPressing the button on the control panelchanges the signal in the order of [Input 1], [Input 2],[Input 3], and [Input 4].Correcting the keystone effectYou can correct the keystone effect that occurs whenthe projector is installed with tilt or when the screen istilted.zThe amount and range of the correction differdepending on the input signal.zWith certain settings, the image may distort for amoment.zTo achieve the corrected image, the signalundergoes digital compression before projectionand lines and text may be altered slightly fromthose of the original image.zFor details on the correction, refer to [Keystone] inthe [Screen] menu.button1)Press the button on theremote control.■zEach press of the button switches the displaybetween the standard keystone effect correctiondisplay and the corner correction display.■■Standard keystone effectcorrectionCorrects the keystone effect vertically and horizontally.1)While [Keystone] is displayed, press▲▼◀▶of the direction in which youwant to make the correction.NotezPressing the button on the remotecontrol for at least three seconds while [Keystone]is displayed returns the image to the uncorrectedstate.■■Corner correctionCorrects distortion at the corners of the image.1)While [Keystone] is displayed, pressthe corner to correct.■zEach press of the button moves the selectedcorner clockwise.2)Press▲▼◀▶to correct the distortion.NotezPressing the button on the remotecontrol for at least three seconds while [Keystone] isdisplayed returns the image to the uncorrected state.Selecting picture qualitymodePressing the button on the remotecontrol displays the menu for the currently selected[Image select], then each subsequent press of thebutton changes the mode.button[Standard][Standard][Real][Cinema][Dynamic][Dynamic][Image 1] -[Image 10][Image 1] -[Image 10]NotezFor details, refer to “[Image select] menu”(page49).