[Setting] menu68 - ENGLISHSettings[Power management]1)Press▲▼to select [Powermanagement].2)Press the ■zThe sub menu 2 is displayed.3)Press▲▼to switch the setting.[Off]Cancels power managementfunction.[Ready]Turns off the lamps and startscooling when the time set using[Timer] has elapsed. While lamp isbeing cooled, the standby indicator, and the powerindicator are flashing,you cannot operate the projector.When lamp cooling has finished,the power indicator continues flashing and the standbyindicator lights upinstead of flashing, indicating thatthe projector is now in the powermanagement mode.From this point, if a signal is inputor operations are performed on theprojector, the lamps will turn on andthe projection will start.[Shut down]Turns off the lamps and startscooling when the time set using[Timer] has elapsed. During lampcooling, you cannot operate theprojector.When lamp cooling has finished,the power will turn off.[Timer]Sets times from 1 - 30 minutes.NotezThe factory default setting is [Off].zThe power management function cannot be usedwhen the freeze function (page37) or shutterfunction (page37) is in use.zWhen the power management function is started,[P-timer] is reset.[Direct on]This is a function for automatically switching onthe power of the projector when the power cord isconnected, without requiring operations on the power button on the remote control or the power STAND-BY> button on the control panel.1)Press▲▼to select [Direct on].2)Press the ■z▲▼are displayed over the sub menu 2.3)Press▲▼to switch the setting.[Off][On][Off]Enables normal operations to turnon/off the power.[On]Allows power to be turned ondirectly.NotezBe sure to turn on/off the power using the correctoperations.zPressing the power button on the remotecontrol or the power button onthe projector will not turn on the power until thelamp cooling has finished and the lamps are readyto be turned on again.
