[Setting] menuENGLISH - 73Settings■■[Filter counter reset]Resets the value of [Filter counter].After replacing the filter, be sure to reset thecounter.1)Select [Filter counter reset], and pressthe ■zA screen for confirming whether to reset isdisplayed.2)Select [Yes], and press the button.■zThe confirmation screen is displayed.3)Select [Yes], and press the button.NotezReset only after replacing the filter.zWhen reset, the display of [Filter warning]disappears.[P-timer]1)Press▲▼to select [P-timer].2)Press the ■zThe sub menu 2 is displayed.3)Press▲▼to select an item.■■[Count up]Elapsed time is counted from 00 min 00 sec.Elapsed time from 00 min 00 sec to 180 min00 sec is displayed.■■[Count down]Elapsed time is counted down from the set time.Set the time using [Timer].■■[Timer]Sets the [Count down] time.1)Select [Timer], and press the■z▲▼are displayed over the sub menu 2.2)Press▲▼to select an item.NotezThe factory default setting is “10 minutes”.zWhen [Count up] is selected, this item is grayed outand cannot be selected.■■[Start]Starts the count-up or countdown.1)Select [Start], and press the button.■zThe menu screen is cleared and the timer isdisplayed.■■[Stop]Pauses the count-up or countdown.1)Select [Stop], and press the button.■zThe stopped state of the timer is displayed forapproximately three seconds, then the displayreturns to the menu screen.■■[Restart]Restarts the count up or countdown that waspaused using [Stop].1)Select [Restart], and press the■zThe menu screen is cleared and the timer isdisplayed.■■[Reset]Resets the counted time during operation.1)Select [Reset], and press the■zThe count up is returned to “000:00” and thecountdown is returned to the time set on thetimer.■■[Exit]Exits the presentation timer during operation.1)Select [Exit], and press the button.■zThe timer ends, and the screen display returnsto the sub menu.NotezYou can also use [P-timer] by pressing the button on the remote control.