Chapter 4 Settings — [DISPLAY OPTION] menuENGLISH - 1075) Press qw to switch the item.f The items will switch each time you press the button.[DEFAULT] Standard setting.[SCREEN FIT] Changes the EDID data according to the [SCREEN FORMAT] setting.[USER] Sets the [RESOLUTION] and [VERTICAL SCAN FREQUENCY] items as EDID.f Proceed to Step 10) when [DEFAULT] or [SCREEN FIT] is selected.6) Press the button.f The [RESOLUTION] screen is displayed.7) Press asqw to select [RESOLUTION].f Select [1024x768p], [1280x720p], [1280x768p], [1280x800p], [1280x1024p], [1366x768p], [1400x1050p],[1440x900p], [1600x900p], [1600x1200p], [1680x1050p], [1920x1080p], [1920x1080i], or [1920x1200p].8) Press the button.f The [VERTICAL SCAN FREQUENCY] screen is displayed.9) Press qw to switch [VERTICAL SCAN FREQUENCY].f Select [60Hz], [50Hz], [30Hz], [25Hz], or [24Hz] when [1920x1080p] is selected for [RESOLUTION].f Select [60Hz], [50Hz], or [48Hz] when [1920x1080i] is selected for [RESOLUTION].f Select [60Hz] or [50Hz] when anything other than following is selected for [RESOLUTION].g [1920x1080p], [1920x1080i]10) Press the button.f The confirmation screen is displayed.11) Press qw to select [OK], and press the button.Notef Settings in [RESOLUTION] and [VERTICAL SCAN FREQUENCY] are displayed in the [DIGITAL LINK IN] screen.f Setting of the resolution and the vertical scanning frequency may be necessary on the computer or video device in use.f The computer, video device, or projector in use may require the power to be turned off and on again after setting.f The output with the set resolution or vertical scanning frequency may not be possible depending on the computer or video device in use.[SDI IN](Only for PT-RZ770, PT-RZ660)Set this item in accordance with the signal input to the terminal.Setting [SIGNAL LEVEL]Select the amplitude of the signal to input.1) Press as to select [SDI IN].2) Press the button.f The [SDI IN] screen is displayed.3) Press as to select [SIGNAL LEVEL].4) Press qw to switch the item.[64-940] Normally use this setting.[4-1019] Select this item when gray is displayed as black.Setting [BIT DEPTH]1) Press as to select [SDI IN].2) Press the button.f The [SDI IN] screen is displayed.3) Press as to select [BIT DEPTH].
