Chapter 3 Basic Operations — Switching on/off the projectorENGLISH - 61f To set the projector based on luminanceLuminance (lm)When [CONSTANT MODE] is set to [OFF] When [CONSTANT MODE] is set to [AUTO] or [PC][MAX LIGHTOUTPUT LEVEL](%)[LIGHT OUTPUT](%) Runtime (hour)[MAX LIGHTOUTPUT LEVEL](%)[LIGHT OUTPUT](%) Runtime (hour)6 000 100.0 100.0 20 000 ― ― ―5 500 100.0 92.0 22 000 100.0 ― ―5 000 100.0 83.0 24 000 100.0 83.0 4 0004 500 100.0 75.0 26 000 100.0 75.0 7 0004 000 100.0 67.0 28 000 100.0 67.0 11 0003 500 100.0 58.0 29 500 100.0 58.0 16 0003 000 100.0 50.0 31 500 100.0 50.0 22 5002 500 100.0 42.0 33 500 100.0 42.0 30 0002 000 100.0 33.0 35 000 100.0 33.0 39 000Notef The runtime may be shorter than the estimation due to the influence of characteristics of each light source, conditions of use, installationenvironment, etc.f The duration of use is referred to as the runtime when you use the projector successively. The duration of use is an estimated duration andis not the warranty period.f If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.Initial setting (installation setting)Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode.Refer to “Installation mode” (x page 32) for details.After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →[PROJECTION METHOD].1) Press qw to switch the setting.3/7ENTER SETCHANGEChange the projection method (FRONT/REAR,FLOOR/CEILING) if the screen display is upside downor inverted.PROJECTION METHODINITIAL SETTINGFRONT/REARFLOOR/CEILINGMENU SELECTFRONTAUTO2) Press the button to proceed to the initial setting.
