Chapter 2 Getting Started — Setting upENGLISH - 33r Angle sensorThe range of the installation attitude that is detected by the angle sensor built-in the projector is as follows.30°30°Floor standing installationFloor standing installationProjection directionCeiling mount installationParts for installation (optional)The projector can be installed on the ceiling by combining the optional Ceiling Mount Bracket (Model No.:ET-PKD120H (for High Ceilings), ET-PKD120S (for Low Ceilings), ET-PKD130H (for High Ceilings, 6-axisAdjustment)) and the Ceiling Mount Bracket (Model No.: ET-PKD130B (Projector Mount Bracket)).f Be sure to use the Ceiling Mount Bracket specified for this projector.f Refer to the Installation Instructions of the Ceiling Mount Bracket when installing and setting up the projector.Attentionf To ensure projector performance and security, installation of the Ceiling Mount Bracket must be carried out by your dealer or a qualifiedtechnician.Projected image and throw distanceInstall the projector referring to the projected image size and projection distance. Image size and image positioncan be adjusted in accordance with the screen size and screen position. The projection relation between thescreen and the projector differs from that of other lenses, when the Fixed-focus Lens (Model No.: ET-DLE030) isattached. Refer to “For the Fixed-focus Lens (Model No.: ET-DLE030)” (x page 34) for details.f Following illustration is prepared on the assumption that the projected image size and position have beenaligned to fit full in the screen.SDL (LW/LT)L1L1L (LW/LT)SW SHHSHSWProjected imageScreenScreen(Unit: m)L (LW/LT)*1 Projection distanceL1 Lens protrusion dimensionSH Projected image heightSW Projected image widthH Distance from the lens center to the bottom edge of the projected image
